Peering with xlm.sh nodes
xlm.sh runs its own IPFS nodes, and every site visited through xlm.sh is pinned on them. If you run an IPFS node, you can keep a permanent connection to these nodes ("peering"), so your node fetches xlm.sh sites directly instead of searching the network first.
Nodes
| Node | Address | Peer ID |
|---|---|---|
| Alice | /dnsaddr/alice.ipfs.xlm.sh | 12D3KooWAUrkQQxX7KXCPjxPRMj82h5LQLNWMLDkPbFGTHqYMsdy |
| Bob | /dnsaddr/bob.ipfs.xlm.sh | 12D3KooWFeQUCoAC1DseHPZtGN7MGZTumadyv3xR9RDhhaBpTX35 |
The /dnsaddr/ addresses resolve to the nodes' current IPv4/IPv6 addresses (TCP and QUIC), so they keep working if a node moves.
Kubo
Add the nodes to Peering.Peers:
shell
ipfs config --json Peering.Peers '[
{"ID": "12D3KooWAUrkQQxX7KXCPjxPRMj82h5LQLNWMLDkPbFGTHqYMsdy", "Addrs": ["/dnsaddr/alice.ipfs.xlm.sh"]},
{"ID": "12D3KooWFeQUCoAC1DseHPZtGN7MGZTumadyv3xR9RDhhaBpTX35", "Addrs": ["/dnsaddr/bob.ipfs.xlm.sh"]}
]'This replaces the whole list; if you already peer with other nodes, add these two entries to your existing list (ipfs config Peering.Peers shows it). Then restart the daemon.
To check the connection:
shell
ipfs swarm peers | grep -E '12D3KooWAUrkQQxX7KXCPjxPRMj82h5LQLNWMLDkPbFGTHqYMsdy|12D3KooWFeQUCoAC1DseHPZtGN7MGZTumadyv3xR9RDhhaBpTX35'Other implementations
Use the addresses and peer IDs from the table above with your implementation's peering or "always connect" setting.